DiSC3(5)

SKU: orb2813897

Description

DiSC3(5) iodide is a membrane-potential-sensitive fluorescent probe that exhibits quenching upon hyperpolarization and enhanced fluorescence upon depolarization, with Ex/Em of 622/670 nm. It is widely used for real-time monitoring of mitochondrial membrane potential dynamics in both cellular and isolated organelle studies.

Key Properties

• CAS Number: 53213-94-8
• MW: 546.53
• Purity: 99.96%
• Formula: C₂₅H₂₇IN₂S₂
• SMILES: [I-].S1C=2C=CC=CC2N(C1=CC=CC=CC=3SC=4C=CC=CC4[N+]3CCC)CCC
• Target: Others
• Solubility: DMSO:4 mg/mL (7.32 mM)

Bioactivity

• In Vitro:
  Instructions I. Solution preparation 1. Stock solution preparation: Stock solutions are prepared at 1-5 mM in DMSO or EtOH. Note: The unused portion of the stock solution should be stored at -20°C. Avoid repeated freezing and thawing. 2. Working solution preparation: Dilute the stock solution into a suitable buffer, such as pure DMEM, HBSS or PBS, to make a 1 to 5 uM working solution. Note: The concentration of the working solution should be determined empirically for different cell types and/or experimental conditions. It is recommended to test at concentrations over a range of at least ten times. II. Operation steps 1. Staining suspended cells: 1) Suspend cells in the dye working solution at a density of 1×10^6/mL. 2) Incubate at 37°C for 2-20 minutes. The incubation time depends on the cell type. Incubate for 20 minutes first, then optimize as needed to obtain uniform labeling. 3) Centrifuge the labeled suspension tube at 1000 to 1500 rpm for 5 minutes. 4) Remove the supernatant and gently resuspend the cells in pre-warmed (37°C) growth medium. 5) Wash twice. 2. Staining adherent cells: 1) Grow adherent cells on sterile glass coverslips. 2) Remove the coverslips from the growth medium and gently drain the excess medium. Place the coverslips in a humidity chamber. 3) Pipette 100 μL of the dye working solution into the corner of the coverslip and gently agitate until all cells are covered. 4) Incubate the coverslips at 37°C for 2-20 minutes. Incubation time varies depending on cell type. Start with a 20-minute incubation and optimize as needed to obtain uniform labeling. 5) Drain the dye working solution and wash the coverslips two to three times with growth medium. For each wash cycle, cover the cells with pre-warmed growth medium, incubate for 5-10 minutes, and then drain the medium. III. Microscope detection. IV. Flow cytometer detection: Cells labeled with DiS can be analyzed using the conventional FL3 flow cytometer detection channel.

Storage & Handling

• Storage: keep away from direct sunlight,store at low temperature | Powder: -20°C for 3 years | In solvent: -80°C for 1 year | Shipping with blue ice/Shipping at ambient temperature.
• Expiration Date: 12 months from date of receipt.
• Disclaimer: For research use only

Alternative Names

3,3'-Dipropylthiadicarbocyanine iodide

Compound Identifiers

PubChem CID

119487